Cisco 300-370 Exam Study Guide

Question No. 1

An engineer wants to run the Voice Audit tool in PI and wants to be able to verify:

* that clients will be capable of having static IPs

* whether or not Call Admission Control is enabled

Which two rules field descriptions must be checked in the report? (Choose two.)

• A. DHCP assignment
• B. CAC: max bandwidth
• C. ACM
• D. DTPC
• E. load-based CAC

Question No. 2

Refer to the exhibit.

You are troubleshooting an AP that fails to join the WLC.

What is a possible cause of the issue?

• A. The WLC has the wrong time.
• B. There is a regulatory domain mismatch.
• C. The certificate is expired.
• D. There is an invalid management interface.

Question No. 3

An engineer has run the debug dhcp packet enable command on the wireless LAN controller CLI. Which field contacts the IP address offered to the client?

• A. siaddr
• B. ciaddr
• C. chaddr
• D. yiaddr
• E. giaddr

Question No. 4

An engineer is concerned about rogue-on-wire and wants to enable port security.

Which guideline must the engineer follow?

• A. Configure ACLs on the switch.
• B. Configure static mac addresses on the switch ports that the APs are connected.
• C. Enable port security on dynamic access ports.
• D. Use 802.1x with port security to prevent MAC spoofing.

Question No. 5

Which statement about the join process of the access point is true?

Refer to the exhibit.

• A. The time on the controller is outside of the certificates validity time interval, so the join phase failed.
• B. The AP successfully joined the controller.
• C. The AP moved from this controller to its primary controller.
• D. The AP failed to join because the MAC address of the AP was not correct on the controller.
• E. The controller rejected all discovery requests from the AP because they were not received on the management interface subnet.