Quick Study For Cisco 642-885 Exam With Practice Questions

Money back guarantee of Cisco Deploying Cisco Service Provider Advanced Routing 642-885 exam is offered on the both products in case of a failure because the experts are confident about the quality and authenticity of the both products practice test software and PDF files. Save your time and money both and prepare Cisco Certified Network Professional Service Provider 642-885 certification exam with the internationally recognized practice test software and PDF booklet. PDF files consist of Latest Cisco 642-885 exam questions that realy helps you in your acutal Cisco 642-885 exam.

♥♥ 2018 NEW RECOMMEND 642-885 Exam Questions ♥♥

642-885 exam questions, 642-885 PDF dumps; 642-885 exam dumps:: https://www.dumpsschool.com/642-885-exam-dumps.html (131 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 642-885 Dumps Exam Questions and Answers:

Question: 21

A junior network engineer has just configured a new IBGP peering between two Cisco ASR9K PE routers in the network using the loopback interface of the router, but the IBGP neighborship is not able to be established. Which two verification steps will be helpful in troubleshooting this problem? (Choose two.)

A. Verify that the network command under router BGP is configured correct on each router for announcing the router’s loopback interface in BGP
B. Verify that the ibgp-multihop command under the BGP neighbor is configured correctly on each router
C. Verify that the loopback interfaces are reachable over the IGP
D. Verify that the update-source loopback command under the BGP neighbor is configured correctly on each router
E. Verify that the ttl-security command under the BGP neighbor is configured correctly on each router to enable the router to send the BGP packets using a proper TTL value
F. Verify that the UDP port 179 traffic is not being blocked by an ACL or firewall between the two IBGP peers

Answer: C, D

Question: 22

Refer to the exhibit for the outputs from an ASR9K router.

Why did the ping fail?

A. The ping command is missing the ipv6 option: ping ipv6 2001:db8:10:1:10::1/128
B. There is a problem with the IS-IS configurations
C. The fe80::eab7:48ff:fe2c:a180 next-hop is not reachable
D. The prefix length should be removed from the IPv6 address in the ping command:
ping ipv6 2001:db8:10:1:10::1
E. IPv6 is not enabled on the Gi0/0/0/0 interface
F. The IPv6 neighbor discovery protocol is not enabled on the Gi0/0/0/0 interface

Answer: D

Question: 23

Which two BGP mechanisms are used to prevent routing loops when using a design with redundant route reflectors? (Choose two.)

A. Cluster-list
B. AS-Path
C. Originator ID
D. Community
E. Origin

Answer: A, C

Explanation:
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.7/routing/configuration/guide/rc37bgp.html
As the iBGP learned routes are reflected, routing information may loop. The route reflector model has the following mechanisms to avoid routing loops:
•Originator ID is an optional, nontransitive BGP attribute. It is a 4-byte attributed created by a route reflector.
The attribute carries the router ID of the originator of the route in the local autonomous system. Therefore, if a misconfiguration causes routing information to come back to the originator, the information is ignored.
•Cluster-list is an optional, nontransitive BGP attribute. It is a sequence of cluster IDs that the route has passed. When a route reflector reflects a route from its clients to nonclient peers, and vice versa, it appends the local cluster ID to the cluster-list. If the cluster-list is empty, a new cluster-list is created. Using this attribute, a route reflector can identify if routing information is looped back to the same cluster due to misconfiguration. If the local cluster ID is found in the cluster-list, the advertisement is ignored.

Question: 24

Which two statements correctly describe the BGP ttl-security feature? (Choose two.)

A. This feature protects the BGP processes from CPU utilization-based attacks from EBGP neighbors which can be multiple hops away
B. This feature prevents IBGP sessions with non-directly connected IBGP neighbors
C. This feature will cause the EBGP updates from the router to be sent using a TTL of 1
D. This feature needs to be configured on each participating BGP router
E. This feature is used together with the ebgp-multihop command

Answer: A, D

Explanation:
http://packetlife.net/blog/2009/nov/23/understanding-bgp-ttl-security/

Question: 25

When implementing source-based remote-triggered black hole filtering, which two configurations are required on the edge routers that are not the signaling router? (Choose two.)

A. A static route to a prefix that is not used in the network with a next hop set to the Null0 interface
B. A static route pointing to the IP address of the attacker
C. uRPF on all external facing interfaces at the edge routers
D. Redistribution into BGP of the static route that points to the IP address of the attacker
E. A route policy to set the redistributed static routes with the no-export BGP community

Answer: A, C

Explanation:
Source-Based RTBH Filtering
With destination-based black holing, all traffic to a specific destination is dropped after the black hole has been activated, regardless of where it is coming from. Obviously, this could include legitimate traffic destined for the target. Source-based black holes provide the ability to drop traffic at the network edge based on a specific source address or range of source addresses.
If the source address (or range of addresses) of the attack can be identified (spoofed or not), it would be better to drop all traffic at the edge based on the source address, regardless of the destination address. This would permit legitimate traffic from other sources to reach the target. Implementation of source-based black hole filtering depends on Unicast Reverse Path Forwarding (uRPF), most often loose mode uRPF.
Loose mode uRPF checks the packet and forwards it if there is a route entry for the source IP of the incoming packet in the router forwarding information base (FIB). If the router does not have an FIB entry for the source IP address, or if the entry points to a null interface, the Reverse Path Forwarding (RPF) check fails and the packet is dropped, as shown in Figure 2. Because uRPF validates a source IP address against its FIB entry, dropping traffic from specific source addresses is accomplished by configuring loose mode uRPF on the external interface and ensuring the RPF check fails by inserting a route to the source with a next hop of Null0.
This can be done by using a trigger device to send IBGP updates. These updates set the next hop for the source IP to an unused IP address that has a static entry at the edge, setting it to null as shown in Figure 2.

Question: 26

Refer to the topology diagram shown in the exhibit and the partial configurations shown below.

Once the attack from 209.165.201.144/28 to 209.165.202.128/28 has been detected, which additional configurations are required on the P1 IOS-XR router to implement source-based remote-triggered black hole filtering?
!
router bgp 123
address-family ipv4 unicast
redistribute static route-policy test
!

A. router static
address-family ipv4 unicast
209.165.202.128/28 null0 tag 666
192.0.2.1/32 null0 tag 667
!
route-policy test
if tag is 666 then
set next-hop 192.0.2.1
endif
if tag is 667 then
set community (no-export)
endif
end-policy
!
B. router static
address-family ipv4 unicast
209.165.201.144/28 null0 tag 666
192.0.2.1/32 null0 tag 667
!
route-policy test
if tag is 666 then
set next-hop 192.0.2.1
endif
if tag is 667 then
set community (no-export)
endif
end-policy
!
C. router static
address-family ipv4 unicast
209.165.201.144/28 null0 tag 666
192.0.2.1/32 null0
!
route-policy test
if tag is 666 then
set next-hop 192.0.2.1
set community (no-export)
endif
end-policy
D. router static
address-family ipv4 unicast
209.165.202.128/28 null0 tag 666
192.0.2.1/32 null0
!
route-policy test
if tag is 666 then
set next-hop 192.0.2.1
set community (no-export)
endif
end-policy
!

Answer: C

New Updated 642-885 Exam Questions 642-885 PDF dumps 642-885 practice exam dumps: https://www.dumpsschool.com/642-885-exam-dumps.html